DJI FPV System Mount for TBS Source One V3

This is a 3D prined TPU mounts for the DJI Air unit and antennas for the TBS source on V3 frame. This lets you use the digital FPV system with your source one frame in a stylish way. The Ait unit is mounted in the centre, maintaining the COG.

Cleaned vs Raw

This part takes quite some time to clean up, so if you want to save some money we can sell you this with supports included, just how it comes out of the 3D printer. Otherwise select the cleaned version where we will remove the support material. To remove support material carefully put the part into very hot water to warm it up, and remove the support material with some pliers.

Assembly

When assembling, insert antennas first, then connect the antennas to the air unit, then slide prints onto frame and last slide top carbon in from the front. kind of assembles like a puzzle. holes in antenna mounts are for adding zip ties for a little extra security if you want.
(on air unit mount, the front is the short side. see photo) One more thing, you need to use 20mm stack screws for this to work.

Desgiend by billyrebellion